Blog

A manufacturing process is generally a good candidate for robot automation when the task is repetitive, the parts are reasonably consistent from cycle to cycle, and the production volume is high enough to pay back the investment within an acceptable timeframe — but none of these conditions has to be

The spare parts worth adding to your original purchase order are the ones with long manufacturing or shipping lead times, not the parts that wear out fastest — because ordering a long-lead part on day one, in the same shipment as the machine, is both faster and often cheaper than ordering it later a

Belt-driven spindles deliver the strongest low-speed torque and are best suited to heavy cutting on steel and cast iron, but top out at lower speeds (commonly under 10,000 RPM) and generate more noise and vibration. Direct-drive spindles couple the motor directly to the spindle shaft, offering highe

A bar feeder is generally the more economical choice for high-volume production of parts made from round bar stock, since it's lower cost, requires less integration complexity, and adds only 2–3 seconds between parts. A robot loading system is generally the more economical choice when part variety m

The right number of ATC (automatic tool changer) stations depends on how many distinct tools your typical part actually requires, not on buying the largest magazine available. As a general guideline: simple machining with straightforward geometry typically needs 8–12 stations; general job-shop produ